Usually requires including code within your script to display message boxes or However, as you then must find all logic errors in the script. This does not mean the script actually worked,
You must continually update, run, and check the log until the script finally Only then is the syntax checked, and errors written to the HomeSeer log. Has been to copy them to the HomeSeer Script folder and then try running them. Time consuming because the only way of testing the scripts as they are developed Scripts and plug-ins can now be developed using VB.NET or CSHARP.NET instead of the vBasicĭeveloping even very simple HomeSeer scripts can be frustrating and HomeSeer has been based upon the Microsoft. Scripts to control the home automation environment. One of the most powerful features of the HomeSeer product is the ability to write While tenScripting3 will run on either HS3 or HS4, there is an upgraded tenScripting4 that will only run on HS4 and includes additional features tailored for an HS4 environment. The legacy version for HS2 can be found here. This program requires HomeSeer 3.0 or later (including HS4). You will receive a prompt that the configuration has been loaded and you should be all set! Because we moved over the information from the Config folder, your plugins should be all set up as they were.Ten Scripting HomeSeer Script Development for HS3 Since you already brought over config data the plugins should run as they did before.
#Hs3 homeseer install
In HS4 click on the plugins menu and install any plugins that you need.
#Hs3 homeseer software
Now, start the HS4 software again and register it!.Next, move onto the Data folder in HomeSeer HS3 and copy its contents into the Data folder in HomeSeer HS4. When asked, select Replace the files in the destination.When asked, select Replace the files in the destination. Copy the contents of the Config folder in HomeSeer HS3 to the Config folder in HomeSeer HS4.Completing the following steps while HS4 is running will cause issues.
#Hs3 homeseer registration
You should be brought to the license registration page where you can enter your license. A shortcut to the HS4.exe will be on your desktop so launch that.By default this would be C:\Program Files (x86)\HomeSeer HS3 Now run the HS4 installer and when it asks for a target directory, select the folder where HS3 is installed.This will prevent the removal of anything you added to your system such as plugins, data, or config files. Select No when prompted to remove HomeSeer HS3 settings and temporary files. Uninstall HS3 from Add/Remove programs.If for some reason HS4 does not start or your data is not imported correctly, uninstall HS4 and try the alternate method. Using this method you will end up with an HS4 system that has all of your plugins installed and configured.Installing and Setting up HS4 (Preferred Method)